Thermal performance of ultra-thin flattened heat pipes with composite wick structure
回应时间：
2020-11-01
原作者：Yong Lia,b, Wenjie Zhoua, Jiabin Hea, Yuying Yanb, Bo Lib, Zhixin Zenga*a School of Mechanical and Automotive Engineering, South China University of Technology, Guangzhou 510640, China*b Fluids & Thermal Engineering Research Group, Faculty of Engineering, University of Nottingham, UK



择要：This study proposes three composite wick structures (copper power or mesh sintered on grooved tube), namely, single arch-shaped sintered–grooved wick (SSGW), bilateral arch-shaped sintered–grooved wick (BSGW), and mesh–grooved wick (MGW), to improve the thermal performanceᩚᩚᩚᩚᩚᩚ⁤⁤⁤⁤ᩚ⁤⁤⁤⁤ᩚ⁤⁤⁤⁤ᩚ𒀱ᩚᩚᩚ of ultra-thin heat pipes (UTHPs). Phase-change flattening technology is employed to fabricate UTHPs. The morphologies of the wick structures after flattening are observed. An experimental apparatus is setup to investigate the thermal performance of UTHP samples under incremental heat loads. The heat transfer limits of UTHP are theoretically and experimentally analyzed. Capillary limit is found to be the main heat transfer limit, and the theoretical values of the samples with SSGW and BSGW are in good agreement with the experimental results. Results indicate that the maximum heat transport capacities are 12 W, 13W and 14 W, under the corresponding optimum filling ratios of 70%, 70%, and 80%, for the SSGW, BSGW and MGW UTHPs, respectively. Evaporation and condensation thermalꦐ resistances of UTHP samples increase with the increase in the filling ratio before the occurrence of dry-out. UTHPs with SSGW have the least evaporation thermal resistance whereas UTHPs with MGW have the least condensation thermal resistance.
相干保举
Analysis of Collapse in Flattening a Micro-grooved Heat Pipe
Analysis of Collapse in F...
做者：Yong Li, Ting He, Zhixin ZengSchool o...
Comparison of radial forging between the two- and three-split dies of a thin-walled copper tube duri
Comparison of radial forg...
小说作者：Yong Li, Jinlong Huang, Guangwen Huan...